Table 6–1 Workstation Card Troubleshooting Tips
Problem
Possible Solution
Computer
does not
boot up
properly.
Verify that the installation instructions were properly followed.
Check that the card is properly installed in your system and
connected to your monitor.
If you have problems during start-up, restart your computer in
Safe Mode. While starting Windows XP, press and hold
F8
until you
see the Advanced Options Menu. Use the arrow keys to select
Safe
Mode
, and press
Enter
.
Check the system configuration utility of your operating system for
the interrupt assignments.
Contact ATI’s Customer Care or your local technical support.
There is no
display.
Make sure the card is seated properly in its slot.
Make sure that the monitor cable is securely fastened to the card.
Make sure that the monitor and computer are plugged in and
receiving power.
If necessary, disable any built-in graphics capabilities on your
motherboard. For more information, consult your computer’s
manual or manufacturer. (Note: some manufacturers do not allow
the built-in graphics to be disabled or to become the secondary
display.)
Make sure that you selected the appropriate monitor when you
installed your enhanced driver.
Make sure that the display resolution and refresh rate settings you
have selected are supported by the monitor you have connected.
There are
screen
defects.
Make sure your monitor supports the resolution and horizontal
(kHz) and vertical (Hz) refresh rates as required by the graphics
card. Check your current resolution, refresh rate, and color depth
settings in the Settings and Monitor tabs in your Display Properties
dialog.
Caution:
Ensure that both the graphics card and monitor support the
resolution and refresh rates you select. Incompatible resolution/
refresh rate selection may result in monitor damage. Refer to your
monitor's documentation for recommended resolutions and
refresh rates.
18
Reference
ATI™ FireMV™ 2260
©
2008
Advanced Micro Devices, Inc.
Summary of Contents for ATI FireMV 2260
