USER
MANUAL
810NG
T
W
ARNINGS
A.3
7845470-01 03/20
subject to change without notice
LIFTING COMPONENT
- Excessive forces if lifting components other than hook are used
IP PROTECTION LEVEL
- Electric system faults (safety and controls)
WARNINGS
- Do NOT use the crane if the operating conditions are incompatible with the instructions given in
this manual. Specifically, the user must contact the crane manufacturer if the environmental
temperature is outside the range given in this manual.
- Handling of loads at heights requires full risk assessment: strictly adhere to the load charts and
always fully extend the stabilizers.
- Suspended loads must not be left unsupervised: put the load on a stable place before leaving the
control station.
- Do not slew the crane at max. speed up to the end of stroke (dead point), but approach slowly.
- Clear any snow or ice from the crane booms to prevent excessive stress caused by the extra
weight and to ensure that movement of telescopic components is not affected.
- Contact an authorised assistance centre before using or transporting the crane in a marine
environment.
- The lifting component to which the diagrams refer in this manual is the crane hook. If other lifting
components are used, the user must contact an authorised assistance centre to obtain a
dedicated load chart.
- Maintenance on the machine which requires welding or grinding is forbidden. Refer to an
authorised assistance centre if repairs or modifications to metalwork are required.