20 Gear Drive, Plymouth Ind. Park, Terryville, CT 06786
Tel: (860) 585-1254 Fax: (860) 584-1973 http://www.amci.com
RBE2-8 User Manual
I
NSTALLING
THE
RBE2-8
21
1.3a DIN Rail Mounting (continued)
1.3a.2 DIN Rail Installation
RBE2-8 Networked Relay Boards can be mounted on EN 05 022 or EN 05 035 DIN Rail. The DIN Rail must
be securely mounted to a panel and solidly grounded before the unit is installed. Grounding is usually accom-
plished through the mounting hardware, by first removing any paint or other material from all surfaces that
may interfere with proper grounding. Another option is to install a heavy gauge wire from the DIN rail to the
system’s ground bus.
1.3a.3 Dimensions
Figure T1.2 shows the dimensions of the RBE2-8 Networked Relay Board when mounting on a DIN rail. The
RBE2-8 does not require any additional spacing when mounting the unit.
Figure T1.2 RBE2-8 DIN Rail Mount Outline
The plastic DIN rail brackets electrically isolate the RBE2-8 from the rest of the system. A
grounding wire from the grounding connection on the power connector to the system ground bus
must be installed. Refer to 1.4,
on page 23 for additional information.
MODULE
STATUS
OUTPUT MODE:
GND
+24V
ON
COMM.
ERROR
MODE
GRN / NORMAL
RED / ALL OFF
OUTPUT
MODE
TOGGLE
NETWORK
STATUS
2.44"
[62.0]
8.98"
[228.1]
4.00"
[101.6]
0.75"
[19.1]
0.91"
[23.0]
0.52"
[13.2]
10.00"
[254.0]
10.40"
[264.2]
0.20"
max.
[5.1]
2.0
7
"
[5
2.
6
]
1.
9
2
"
[48.
8
]
2.
9
4
"
[7
4
.7]
3.
8
0
"
[96.
5
]
2.90
"
Ma
x
.
[7
3.
3]
DIN rail not included.
shown.
EN 05 022 35 x 7.5
DIN rail CL
RESET
MODULE
Summary of Contents for RBE2-8
Page 14: ...RBE2 8 INTRODUCTION RBE2 8 User Manual ADVANCED MICRO CONTROLS INC 14 Notes ...
Page 30: ...PROTOCOL SPECIFIC INFORMATION RBE2 8 User Manual ADVANCED MICRO CONTROLS INC 30 Notes ...
Page 48: ...MODBUS TCP CONFIGURATION RBE2 8 User Manual ADVANCED MICRO CONTROLS INC 48 Notes ...
Page 54: ...LEADERS IN ADVANCED CONTROL PRODUCTS ADVANCED MICRO CONTROLS INC ...