20
2.4.5 CANOPIES
Remove protective film before starting.
Slide the outer canopies over the reflectors from
the U bend end ensuring correct location in re-
flector profile. Line up burner end canopy flush
with burner end reflector. Overlap canopies as
shown in the assembly diagram.
CAUTION — SHARP EDGES!
2x 3x
13
The heater assembly is now complete and can now be installed.
We would recommend that the
burner and heat exchanger be assembled once the heater has been installed in the roof space.
Locate 6 off No.5 torque screws. Position the
blank canopy end cap with the end cap flanges
facing
inwards,
beneath the canopy profile at the
U bend end & fix with screws. Repeat procedure
for 'cut-out' canopy end cap, again ensuring the
flange faces
inwards.
Adjust canopies so that the holes on top align
with each other as detailed in the assembly
instructions. Locate and fix one No.5 torque screw
on every canopy overlap.
1x 2x
2.4.6 CANOPY END CAPS
15
2x 2x
12x 12x
CAUTION — SHARP EDGES!
16
1x 1x
1x 1x
14
2.4.7 GENERAL