19
Repeat this procedure referring to the
assembly diagram for quantities used on specific
models, but noting that the final bracket
is not
bolted to the reflector. (See photo)
Slide 2nd bracket to line up with innermost
slotted hole in 1st reflector, & bolt together using
M6 x 35mm pins, washers & nuts. Bolt 1st & 2nd
reflectors together using end elongated holes in
each.
4x 4x
9
At this stage
all the U bolts should be
fully tightened.
Using M4 setpins & washers fix the 'cut out'
end cap beneath the reflector profile at the
burner end with the
flanges facing outwards.
Locate M4 pins, washers & nuts into holes in
overlapping reflectors as shown.
1x 2x
2.4.4 END CAPS
Using M4 setpins & washers fix the blank end
cap beneath the the reflector profile at the U bend
end with the
flanges facing outwards
.
3x 3x
3x 3x
1x 2x
1x 2x
11
12
3x 3x
3x 3x
2x 2x
8
10