Version 1.0
©Copyright 2020, Ambient LLC. All Rights Reserved.
Page 7
according to the polarity information marked on the battery compartment.
Figure 3
2.
Replace the battery door and screw on tightly.
3.
The transmission status LED will begin flashing once per 12 seconds.
The Console:
Important Note: The power up sequence must be performed in this order (battery first, AC
adapter second) to prevent a low battery indication at power up.
Place the sensor array about 5 to 10 feet from the display console.
Figure 4
1.
Reference Figure 4. Rotate the battery lid counter-clockwise to open the battery door.
2.
Gently pull out the battery pull tab.
3.
Rotate the battery lid clockwise to close the battery door.
4.
Plug the AC adaptor into the DC jack of the console.
5.
After power up, all of LCD segments will be displayed. The console will enter access point
(AP) mode, and the status LED will flash green.
6.
Do not touch any buttons until sensor synchronization is complete.
