13
Fragmentation Threshold:
The value indicates how much of the network resources devoted to
recovering packet errors. The value should remain at its default setting of 2432 bytes. If you have
decreased this value and experience high packet error rates, you can increase it again, but will likely
decrease overall network performance.
RTS Threshold:
The value should remain on its default setting 2432 bytes.
Authentication Type:
It can be selected for “Open System”, “Shared Key” or “Both” for the indication
of an authentication algorithm. “Shared Key” is to be selected while the WEP for PC card and
Access Point are both enabled and setup with the same passphrase key. And “Open System” is for
disabled WEP in Wireless Network system.
Preamble Type:
There is the “Long” or “Short” selection to ensure that systems receiving the
information correctly interpret when the data transmission starts. To select “long” Preamble may be
used to minimize overhead and “Long” to maximize the network data throughput. The default value
will be set for “Long”.
Basic Rate:
The basic transfer rate is to set based on the speed of the wireless network system. For
slower network system is to be selected 1-2 Mbps and faster network 1-2-5.5-11 Mbps.
Auto Rate Fall Back
setting allows you to have flexible automatic data rate adjustment according to
the connection situation.
If you had changed any configuration, please click “
Apply
” Button.
5.
The “IP Setting” Tab
, you can change “IP address” and “IP mask.
IP Address:
The IP address of Wireless Network should be different as the network IP addresses.
IP Mask
: The value should be same as the Subnet Mask address of wireless Network IP address.
If you had changed any configuration, please click “
Apply
” Button.
6.
The “Security” Tab,
WEP (Wired Equivalent Privacy) is a data privacy security mechanism based on a 40
bit shared key algorithm.
