2
www.ambaproducts.com
IMPORTANT INSTRUCTIONS
WARNINGS & PRECAUTIONS
BEFORE INSTALLING THE TOWEL WARMER CAREFULLY READ ALL INSTRUCTIONS
Ensure that VOLTAGE (V) & FREQUENCY (HZ) indicated in the serial number plate correspond to
the voltage & frequency available in the place of installation
At receipt of goods, ensure that packaging is intact:
ANY DAMAGES THAT OCCUR DURING TRANSPORT
ARE NOT COVERED BY THE WARRANTY
•
This heater is hot when in use — to avoid burns do not let bare skin touch hot surfaces
•
For indoor use only
•
Wiring procedures & connections shall be in accordance with the national & local codes having
jurisdiction
•
Piling multiple towels on top of each other increases the risk of discoloring due to heat
•
Discoloration of some towels may occur — this could be the result of fabric makeup, detergent residue,
or
if too many towels are placed on the towel warmer. For these reasons
Amba P
roducts cannot be held
liable for any damage to towels. Consider the option of using a digital heat controller for delicates,
acrylics, or nylon — for further protection do not place items directly on unit
•
When using electrical appliances, basic precautions should always be followed to reduce the risk of fire,
electric shock, & injury to persons, including the following:
•
Utilize the heater only for warming rooms, or warming & drying towels
•
Utilize the heater as described in this manual only. Any other use not recommended by Amba Products
may cause fire, electric shock, or injuries to individuals
•
Use only on 15 ampere branch circuit —a dedicated circuit is not required.
•
The unit has to be connected to a power-supply circuit equipped with an omni-polar disconnection
electrical system, with a distance among contacts of
1/8"
•
Caution: high temperature, risk of fire — keep electrical cords, drapery, furnishings, & other combustibles
away
from
the front of the heater
•
Bad smells may be caused by residues inside the heater, or by the inner plastic parts as unit operates with no
liquids inside (dry system)
•
Do not use heater in case of damaged wire or plug, in case of malfunction, drop, or other kind of circumstance
that
may require adjustments or repair: contact Amba Products
•
We recommend the p.V.C. Protective tape is left in place until the heater is fully installed: please remove tape
from
bracket location first — after the installation, remove the P.V.C. Protective tape to avoid glue residue
•
Be careful while handling the heater to avoid scratching, marking, grazing or denting the surface: these damages
are not covered by the warranty
•
Be careful during installation & use in the presence of children & disabled people
•
To switch off the heater, press the on/off button
•
Wiring the connection to the power source incorrectly will cause sparks & burning/breaking of the heater —consult
installation instructions & wiring diagram carefully
•
Ensure that the room trip switch is off before any maintenance operation
•
Do not insert foreign bodies inside the heater in order to avoid electrical shocks, fire and damages to the heater
•
Do not use the heater close to combustibles, paints, or any other flammable liquid
•
Keep the heater away from water in order to avoid electrical shocks or damage to the unit
•
Always install per local electrical code
Amba Products declines any responsibility if the instructions mentioned above are not kept
