Cleaning, maintenance and repairs
ZG-B
BAG0051.5 02.14
105
Observe legal requirements when disposing of lubricants, e.g.
oils and grease. These legal requirements also affect parts that
come into contact with these lubricants.
Do not exceed a greasing pressure of 400 bar when greasing
with high pressure grease guns.
The following are prohibited:
drilling the running gear.
drilling through existing holes on the transport frame.
welding
load-bearing
components.
Protective measures are necessary, such as covering lines or
extending lines in particularly critical locations
during welding, drilling and grinding work.
when working with cut-off wheels near plastic wires and
electric wires.
Clean the machine thoroughly with water before carrying out
repair work.
Carry out repair work on the machine with the pump switched
off.
Thorough cleaning must be carried out before repair work can be
carried out inside the spray liquid tank. Keep out of the spray liq-
uid tank.
Disconnect the machine cable and power supply from the on-
board computer when carrying out any cleaning or maintenance
work. This applies especially to welding on the machine.