Adjusting the plough
7.5
Adjusting the track width
Depending on the field depth and the pitch setting, correct the
dimension (L) such that the cutting width (S) corresponds to the
respective cutting widths of the rear bodies S.
Each setting correction affects the other setting parameters, which
then also required corrections.
7.6
Adjusting the disc coulter
(1) Adjusting the depth of the disc coulter
After loosening the bolt, set the depth of the disc
coulter by altering the position of the rocker bar
according to desired work depth. Make sure that
the hub does not touch the ground.
When adjusting the rocker bar, make sure that
the teeth engage and that the bolt is securely
tightened again.
(2) Adjusting the lateral distance to the
plough body landside.
The distance between the side of the disc and
the plough body landside should be between 1
and 3 cm, and at least protrude over the fertiliser
skimmer coulter. This distance is achieved by
rotating the coulter shaft.
Rotation is enabled by loosening the clamping
bar. To do so, use the bolt that is further away
from the coulter shaft (better clamping effect).
(3) Adjusting the stop for lateral oscillation.
Adjust the lateral swaying of coulter is to be set
using stop. When there are large quantities of
crop residues, set the disc coulters further to the
front on the holder.
(4) Adjusting the distance from the share.
Adjust the distance from the share by moving
both disc coulters together on the holding bar.
40
Hektor BAG0186.1 07.19
