General safety instructions
23. If using subsoilers, the subsoiler(s) must be dismounted on the
release side and removed to ensure the stability of the plough.
24. Make sure that no people or animals are within the working and
swivelling range of the plough. The implement operator is
responsible for people and animals in work area.
25. All hydraulically controlled folding parts have shear and crush
zones!
26. The implement must only be parked on level, firm, and
horizontal ground.
RISK OF OVERTURNING!
27. The turning cylinder of implements with single-acting turning
cylinder must be hydraulically locked using stop tap.
28. Put the stand supports in the correct position and fasten
securely when mounting or dismounting the plough!
29. Maintenance, repair, and adjustment work shall only be carried
out when the implement has been lowered to the ground.
30. For spare parts or accessories, use only original parts! Do not
make any "independent" changes to the implement.
31. When carrying out electrical welding work on the tractor and
mounted implement, disconnect the cable on the generator
(alternator) and battery!
32. The hydraulic system is under pressure!
33. When connecting the hydraulic hoses to the tractor's hydraulic
system, ensure that the hydraulics are depressurised on both
the tractor side and the implement side!
34. Label coupling sleeves and plugs to exclude operating errors!
When the connections are inverted, the inverse function is
performed (e.g. lifting / lowering)
Risk of accident!
35. Check hydraulic hose lines regularly and replace if damaged or
worn! The replacement lines must comply with the technical
requirements of the implement manufacturer!
36. Fluids (hydraulic oil) escaping under high pressure can
penetrate the skin and cause serious injuries! In the event of
injury, seek medical advice immediately. Risk of infection!
37. Lower the implement on the ground before working on the
hydraulic system. Depressurise system and switch off engine.
38. Check the nuts and bolts regularly for tight fit and retighten if
necessary!
39. For maintenance work - e.g.: the replacement of wearing parts –
that is performed when the implement is raised, always secure
with suitable support mechanisms!
40. Replacement parts must at least meet the technical
requirements stipulated by the implement manufacturer! This is
guaranteed by using original replacement parts.
Hektor BAG0186.1 07.19
17
