3
4
CONTROLLER DIAGRAM
Camera
Propeller
ASC-2080 DIAGRAM
F
DO NOT FLY YOUR ASC-2080 IN FOUL WEATHER!
WARNING
FLIGHT PREPARATION
• Verify that there are 3 “AAA” batteries inside the remote control unit and the ASC-2080 battery has been
fully charged.
• Make sure to be in a large open space preferably a field or a park with an open radius of at least 200 feet.
• Make sure to start your drone on a clean flat level surface before take-off.
• IMPORTANT! Until you have experience in flying your ASC-2080, it is not advised to use in any rate of
wind. Pick a day with zero wind or extremely light wind condition when learning how to fly.
SYNCING YOUR ASC-2080
Important! When syncing your ASC-2080 with the controller always make sure that the drone is on a
flat level surface and that your digital trim settings are in the center position.
1. Before starting, make sure that the power on your controller is off and the battery is removed from the
ASC-2080.
2. Insert the battery into the ASC-2080 and set it down on a flat level surface. Press down the power button
and hold for a few seconds (see diagram F).The LED lights on the drone should begin to flash.
3. Quickly turn ON the remote and you will notice that the top red LED light on the face of the controller
.
4. Push the throttle stick all the way up until it stops and then pull it back all the way down to the
bottom(see diagram below). When pushing the stick up or pulling the stick down you should hear a
high-pitched beep both ways. If the indicator lights on the drone and controller stop flashing and stay
solid on. You have successfully synced your ASC-2080 and are ready to fly. If this doesn’t happen, repeat steps
1-4 again.
• TIP 1: Try not to leave too much time between turning your drone on and turning
on the controller, or your syncing window will time-out.
•TIP 2: Syncing your drone indoors or in the shade will make it easier to see the
LED light indicators on both the controller and the drone.
Move the control stick all the way up
and all the way down, you should
hear two beeps.
The flashing red LED light will
become solid when you are synced.
Power Button
Power Button
Li-Poly Battery
Speed Setting Button
360˚ Stunt Rolls Button
AUTO Start/Land
Throttle/Yaw
Direction Controls
Press to take a photo
Press down & hold to begin
video recording
Power Indicator
ON/OFF Power Switch
Banking Right Trim
Banking Left Trim
Forward Trim
Backward Trim
Safety Guard