TPD
Jul 2016
22
Amate Audio
•
Freq
- EQ center frequency.
•
Gain
- EQ level gain.
•
Q
- EQ Bandwidth. For shelving filters the Q sets the transition in dB/Oct.
•
Type
- Shape of EQ. The available types are:
Bell: Modifies the gain of a certain frequency range, with bell shape
Notch: Eliminates a range around a center frequency
High-Shelf: Modifies the gain of all the range above a selected frequency.
Low-Shelf: Modifies the gain of all the range below a selected frequency.
All Pass: Modifies the phase response, without influencing the frequency response.
Band Pass: Filters out all the range except the defined band.
High Pass: Filters out all the range below a certain frequency.
Low Pass: Filters out all the range above a certain frequency.
6.3.6 Limiter [see Table 4]
A peak-limiter can be set at each input. It is a zero attack time limiter, so it will
immediately act on the signal. The parameters that can be changed are:
•
Thr.
– Threshold: input level at which the signal will be limited.
6.3.7 Phase
– Phase inversion
Change the polarity of the channel by a 180º phase inversion. Select between
Normal or Inverted.
6.3.8 Channel Link
Output channels can be linked in order to set the same parameters on both. Turn the
rotary knob set the link off.
For Amate presets, this is only available in Admin mode.
Q: 2.36
OutL2 PEQ 1
Thr: +7.50dBu
OutL2 Limiter
Name
Type: Bell
OutL2 PEQ 1
Freq: 1000Hz
OutL2 PEQ 1
Gain: 0.00dB
OutL2 PEQ 1
On
OutL2 Link:
Normal
OutL2 Phase:
Summary of Contents for TPD
Page 58: ......
