TPD
Jul 2016
11
Amate Audio
Defined for Amate Audio loudspeakers. Provide extra EQ and limiter
settings to improve the performance of the loudspeaker (i.e.
JK26A+2JK12W).
The user can only modify the input parameters. Cannot be overwritten.
Preset 31 to 100: User presets (Empty).
Free slots to store modifications made on read-only presets.
Only Admin users can load an empty preset.
No. Type
Read-
Only
Name
Out SW
(AUX1)
Out L
(AUX2)
Out R
(AUX3)
1
Generic Yes
Xo100+SW4Ohms LPF 100 Hz
4 ohm Load
HPF 100 Hz
HPF 100 Hz
2
Generic Yes
Xo100+SW8Ohms LPF 100 Hz
8 ohm Load
HPF 100 Hz
HPF 100 Hz
3
Generic
Yes
Xo110+SW4Ohms LPF 110 Hz
4 ohm Load
HPF 110 Hz
HPF 110 Hz
4
Generic
Yes
Xo110+SW8Ohms LPF 110 Hz
8 ohm Load
HPF 110 Hz
HPF 110 Hz
5
Generic Yes
Xo120+SW4Ohms LPF 120 Hz
4 ohm Load
HPF 120 Hz
HPF 120 Hz
6
Generic
Yes
Xo120+SW8Ohms LPF 120 Hz
8 ohm Load
HPF 120 Hz
HPF 120 Hz
7
Generic
Yes
Xo80+SW4Ohms
LPF 80 Hz
4 ohm Load
HPF 80 Hz
HPF 80 Hz
8
Generic
Yes
Xo80+SW8Ohms
LPF 80 Hz
8 ohm Load
HPF 80 Hz
HPF 80 Hz
9
Generic
Yes
Xo90+SW4Ohms
LPF 90 Hz
4 ohm Load
HPF 90 Hz
HPF 90 Hz
10
Generic
Yes
Xo90+SW8Ohms
LPF 90 Hz
8 ohm Load
HPF 90 Hz
HPF 90 Hz
11-
30
Amate
Yes
Specific presets for Amate Audio loudspeakers.
The model list depends on the firmware version
Please refer to the list enclosed with this manual
31-
100
User
No
Empty
Table 3.
Configuration of the in-built presets
WARNING:
Presets marked as Read-Only can be modified, but not
overwritten. To save a modified factory preset, a User slot (in the
position 31 to 100) must be used.
WARNING:
Make sure that you select a preset that matches the load
impedance of the subwoofers. If the total load of the channel is 4 Ohm
select a “4 Ohm load” preset. If the load is 8Ohm, select “8 Ohm load”.
Default presets are optimized for a 4 Ohm load.
5.3 System Optimization
The built-in presets of the
TPD
have been adjusted to obtain the maximum dynamic
range from the amplifier. It is recommended to control the output power by regulating
Summary of Contents for TPD
Page 58: ......
