TPD
Jul 2016
21
Amate Audio
6.3.3 Delay
Adjust the delay by turning the rotary knob. Push this knob to switch the unit
between ms, ft or m.
6.3.4 Crossover [see Table 4]
•
Low Pass
– First adjust the Low Pass Filter cut-off frequency. To switch it off, turn
the rotary knob clockwise until frequency reaches 20 kHz.
Second, press the rotary knob and select from the available types and slopes:
Type: Butterworth, Slopes: 6dB, 12dB, 18dB or 24dB
Type: Bessel. Slopes: 6dB, 12dB, 18dB or 24dB
Type: Linkwitz-Riley. Slope: 12dB or 24dB
Finally, select to enable or disable the filter: Enabled On/Off.
•
High Pass
– First adjust the High Pass Filter cut-off frequency. To switch it off, turn
the rotary knob counter-clockwise until frequency reaches 20 Hz.
Second, press the rotary knob and select from the available types and slopes:
Type: Butterworth, Slopes: 6dB, 12dB, 18dB or 24dB
Type: Bessel. Slopes: 6dB, 12dB, 18dB or 24dB
Type: Linkwitz-Riley. Slope: 12dB or 24dB
Finally, select to enable or disable the filter: Enabled On/Off.
6.3.5 Parametric EQ
Select between one of the 10 available Equalizers on each output channel by using
the keys
< Select
and
Select >
. Browse the parameters by turning the rotary knob
and push the knob to select and confirm the values. The following parameters can
be adjusted for each EQ:
•
Enabled
– When set On, the currently selected EQ is on line.
0.000ms
OutL2 Delay
Signal
Freq: 1500Hz
OutL2 LowPass
XOver
Type: BUT 24dB
OutL2 LowPass
XOver
Type: BUT 24dB
OutL2 HighPass
XOver
Freq: 40Hz
OutL2 HighPass
XOver
Enabled: On
OutL2 PEQ 1
Summary of Contents for TPD
Page 58: ......
