Amate Audio NITID N18W, User Manual

Page: 15 / 25

NITID N18W_N218W Oct 2017
15
Amate Audio
Delay
0.0ms
0.0m
Delay
35.3ms
12.0m

OUT: output level after the limiter. This is the actual signal level after the
signal goes through the limiter. If the threshold is not reached, it will be the
same as the input level. If the threshold is exceeded, there will be a reduction.
The limiter acts over the Peak limiter value. The system has also an
internal RMS limiter that is fixed (see Section 4.7.1).
4.4.3. Delay Menu
In the Delay Menu, it is possible to add a Delay to the signal in the internal DSP.
Press OK to start editing the Delay value. The cursor will blink to show that the value
is being edited. Use the Circular key to modify the value, and press OK to finish
editing.
The value of the Delay is displayed in milliseconds (ms) and meters (m). The value
of the delay ranges from 0 to 40 meters (0 to 117.6ms).
The delay value is applied short after a value has been selected with the
Circular key. When the delay is applied a short fade in / fade out of the
output signal will be performed.
The center led of the circular key will light off while this process is performed, and will
light on again when the new value has been loaded.
4.5. SETUP Menu
When the word SETUP is displayed, press OK. The ECO Mode on/off selection will
show up as in Fig. 15.
Here, use the MENU key to browse all the setup options: ECO Mode, Mute, LCD
Backlight, Keypad Lock and Polarity Reverse.
Press OK to change the value for the displayed selection (switch between ON/OFF).
ECO Mode ECO Mode
Fig. 14. Delay display (left) and Delay while editing (right)
Fig. 15. ECO Mode option inactive (left) and active (right).