Starting the Machine
1. Check oil and fuel levels.
2. Check and clean engine dust filter.
CAUTION!
Never run continuously for more than one
hour without cleaning or changing engine dust filter.
3. Check carburetor air filter. Change if necessary.
(See “Scheduled Maintenance”)
4. Turn propane service valve counterclockwise to
open.
CAUTION!
Always open service valve slowly to allow
pressure to equalize in hoses. Opening quickly may
cause the flow check valve to engage, limiting fuel flow.
5. With the bail throttle in the idle position, engage
the starter by turning the key switch to the starting
position for approximately 5 seconds. If the engine
does not start, release the key switch for 10 seconds,
then try to start again in another 5 seconds.
6. After the engine has started, allow the engine to
warm up for approximately 30 seconds.
WARNING!
Catalytic mufflers require a few minutes to
warm up before effectively removing harmful emissions.
Make sure of proper ventilation during this warm-up
period!
Idling and Stopping the Machine
DANGER!
Allowing the engine to idle excessively will
increase carbon monoxide emissions!
To stop the engine, close the service valve on the fuel
cylinder by turning it clockwise (the engine will stop
when the fuel in the lines is used up). Once the engine
stops, turn the ignition switch off.
Stripping
1. After engine has started, allow approximately 30
seconds for the engine to warm up.
2. If the transport cart is in place, remove it allowing the
brushes to contact the floor.
3. Pull the bail throttle to operating position.
CAUTION!
DO NOT
engage clutch with the brushes
not on the floor.
CAUTION!
DO NOT
run the burnisher without moving
the machine. If the machine is allowed to run in one
spot, damage to the floor may occur.
4. To stop stripping, release the bail throttle.
CAUTION!
DO NOT
add weight to the deck.
CAUTION!
DO NOT
lift up on the handle to add
pressure while stripping.
NOTE:
To not comply with any of the
CAUTION!
statements could cause the engine to overheat and/or
damage the brush / pad holder or drive components.
5. When done stripping, push the machine to the
desired location. Turn off the LP cylinder service
valve. When the fuel is depleted and the engine
stops, turn the key switch OFF.
6. Remove the LP cylinder and store properly. Refer to
Refueling and Storage of Fuel Cylinders.
20
Summary of Contents for Pioneer Eclipse 440ST
