Amano AGP-2000 Series, Installation & Operation Manual, Page: 37 / 40

System Reset
Program Reset
The AGP-2000 program can be reset to the default values if needed. A System Reset
is accomplished through the Test Mode.
1. Press the POWER button on the remote control unit.
2. Press 2 to enter the Test Mode.
3. Enter your four digit password and press the VOL DOWN button.
4. Press 7 to enter the System menu.
5. Press 2 to select RESET.
6. Press 1 for YES if you wish to RESET the program.
Note : All program parameters will be reset to the AGP-2000 default values.
7. Press the VOL DOWN button to Reset the AGP-2000 Program and return to the
Main Test menu.
8. Press the POWER button to return to the Normal Mode.
Clearing the Ram
If it becomes necessary to completely clear the memory and return the system to
it’s default configuration, you must temporarily disconnect the battery located on the
back of the Main PCB as follows:
1. Turn off the machine
2. Disconnect the comms cables (see Figure 3-4).
3. Using needle nose pliers, carefully pull the negative battery lead from its socket.
Caution: Use extreme care to make sure neither the pliers or the battery lead
contacts any runs on the circuit board.
4. Wait at least 5 seconds and carefully re-insert the lead into its socket, connect
the comms cables and turn on the machine.
AGP-2000 Installations and Operations / SERVICE 4 - 9