![background image](http://html1.mh-extra.com/html/amano/agp-2000-series/agp-2000-series_installation-and-operation-manual_2918178030.webp)
Ribbon Replacement
To remove the old ribbon cartridge:
1. Unlock and open the side door panel if you have not already done so.
2. Pull the cover release latch upward.
3. Pull the rear cover release latch towards the front of the unit.
4. Slide the cover up to open it. The cover can be lifted off if needed.
5. Refer to Figure 4-2 below to locate the ribbon cartridge and white nylon retainer
tabs securing the cartridge in place.
6. Pull back on the Printer Release Latches to tilt the printer up and back.
7. Pull up on the Top Retainer Tab to release the ribbon cartridge.
8. Push in the Bottom Retainer Tab while removing the cartridge.
To install a new ribbon cartridge:
1. Turn the Ribbon Advance Knob on the new cartridge so that the ribbon is taut.
2. Pull back on the Printer Release Latches to tilt the printer up and back if you
have not already done so.
3. Position the ribbon cartridge so that the adjustment knob is towards you.
4. Snap the ribbon cartridge into place passing the ribbon under the print head.
5. Make sure the cartridge is fully seated on both sides. Push down on the Top
Retainer Tab to make sure it is securely fastened over the top of the cartridge.
6. Make sure the ribbon passes under the print head and is not twisted. Turn the
adjustment knob on the front of the cartridge to tighten and straighten
the ribbon.
7. When finished, tilt the printer assembly back into place and secure it with the
release latches.
8. Close and lock the cover and door panel when finished.
Note: Use only an RWPV ribbon (Amano part number CE-316250). This ribbon
contains an ink tank which will assure long ribbon life (approximately 50,000 tickets).
Generic ribbons may leak ink onto the platten, gum up the print head and not couple
with the mechanism properly.
Use of other than an Amano approved ribbon will void the warranty.
4 - 2
AGP-2000 Installation and Operations / SERVICE
Figure 4-2, Replacing the Ribbon Cartridge
Summary of Contents for AGP-2000 Series
