Amano AGP-2000 Series, Installation & Operation Manual, Page: 27 / 40

Loading the Ticket Supply
After the power and field wiring to the Ticket Dispenser have been connected, you are
ready to load the tickets into the transport. Refer to Figure 2-4 for the location of
installed ticket boxes.
1. Unlock and open the side door panel if you have not already done so.
2. Pull the front cover release latch upward and pull the rear cover release latch
towards the front of the unit to release the top cover. Lift the cover.
3. Make sure the tie wrap and tickets have been removed from the printer
mechanism.
4. Remove the top of the ticket box and discard.
5. Place the ticket box (or two ticket boxes if dual ticket feed [DTF] will be used) in
the bottom ticket bracket.
Place 3-inch ticket boxes in the machine so the words “Machine Tickets” are in
the upper right of the box. Three-inch tickets will be fed into the printer
mechanism with the preprinted numbers on top, towards the rear of the unit and
the magnetic strip on the right as the tickets exit the machine.
6. Feed the tickets from the rear box into the rear opening of the ticket transport
until resistance is felt. The machine will then grab the tickets and thread them
into position automatically.
7. If dual ticket feed is being used, repeat the procedure with stock from the
second box, this time using the secondary feed in front of the main feed.
AGP-2000 Installation and Operations / INSTALLATION 3 - 13
Figure 3-14 Loading 3-inch Tickets