Amana NTW5400T, Technical Education, Page: 33 / 64

4-
Timer Connectors
Lift Timer Tab
Hold This (Slotted) Shaft
End to Remove Knob
Timer Screw
Timer
Delay
e) Remove the 3/16
˝
hex-head screw
from the front of the timer.
f) Lift the timer locking tab (see the photo
above) so that it clears the hole in the
console. Slide the timer to the left until
the catches clear the console slots, and
remove the timer from the console.
5. To remove the timer:
a) Remove the control knob from the tim-
er as follows: Push the knob in, hold
the rear of the shaft by the slotted end
with a small screwdriver so it does not
move, then pull the knob off the front
of the shaft.
b) Pull the cover and plate off the timer
shaft.
c) Disconnect the two wire connectors
from the timer, and the single connec-
tor from the timer delay terminal.
d) Remove the timer delay from the timer
(see step 4).
6. To remove the water level pressure
switch:
a) Pull the pressure hose off the switch.
b) Disconnect the wire connector from
the switch terminals.
c) Lift the locking tab, rotate the switch
approximately 30
°
CCW so that the
square on the front aligns with the cut-
out, and remove the switch from the
console.
Lift Tab
Water Level Pressure Switch
Pressure Hose
Wire Connector
Rotate
30°
7. To remove the wash temperature/ATC
switch or the options switch:
a) Pull the knob off the switch shaft.
b) Unlatch and disconnect the wire con-
nector from the switch terminals.
c) Lift the locking tab so that it clears the
hole in the console, rotate the switch
approximately 30 ° clockwise so that
the square on the front aligns with the
cutout, and remove the switch from
the console.
Rotate
30°
Wash Temperature/ATC Switch
Wire Connectors
Lift Tabs
Rotate
30°
Continued on the next page.
Options Switch