23
Troubleshooting
(contd)
ICE MAKER
(cont'd)
Topic
Possible Cause
Solution
Ice maker is not
producing enough ice
or ice is malformed or
hollow
Ice maker has just recently been
installed or a large amount of ice
has been used.
Water pressure is too low.
Freezer temperature is too low.
Wait 24 hours for ice production to begin and for
ice maker to restock after emptied.
Low water pressure can cause valve to leak.
Water pressure must be between 20 to 120 p.s.i.
to function properly. Minimum pressure of 35 p.s.i.
is recommended for units with water filters:
Amana Clean
n clear
®
I
#12382901
Amana Clean
n clear
®
II #rR0185034
See the controls section in this manual for
assistance on how to adjust your controls.
Freezer is recommended to be between 0° to 2°F
(-18° to 17°C)
Unit is leaking water
Plastic tubing was used to complete
water connection.
Water pressure is too low.
Improper water valve was installed.
Amana recommends using copper tubing for
installation. Plastic is less durable and can cause
leakage. Amana is not responsible for property
damage due to improper installation or water
connection
Low water pressure can cause valve to leak.
Water pressure must be between 20 to 120 p.s.i.
to function properly. Minimum pressure of 35 p.s.i.
is recommended for units with water filters:
Amana Clean
n clear
®
I #12382901
Amana Clean
n clear
®
II #rR0185034
Check water connection procedure in
Installation
Instructions.
Self-piercing and 3/16" saddle
valves cause low water pressure and may clog
the line over time.
Amana is not responsible
for property damage due to improper
installation or water connection
