background image

Component Testing Procedures

!

WARNING

To avoid risk of electrical shock, personal injury, or death, disconnect power to oven before servicing, unless
testing requires it.

RT2310010   Rev. 1

May 2000

2

Illustration

Component

Test Procedure

Results

31823701

Oven light socket

Remove one wire from receptacle and
test resistance of terminals.

Measure voltage at oven light.

Indicates continuity with bulb screwed in.

120 VAC, see wiring diagram for terminal
identification.
If no voltage is present at oven light,
check wiring or light switches.

0301492

Rocker switch

Measure continuity of switch
positions:
 Closed
 Open

Continuity, if not replace.
Infinite, if not replace.

0304579

COM

NC

NO

Hi temperature
latch switch

Test for voltage at terminals to
chassis when in bake, broil, or clean
mode.
  COM to chassis
Only when latch is engaged:
  NO to chassis

120 VAC

120 VAC

31864501

P3

P4

P5

P6

Relays

P2

P1

1

12

1

Eaton electronic
range control

KRC

Measure voltage at terminals:
 P3 (L1) and P4 (NEU)

Remove leads and measure for
continuity.

Drive requirements
 Bake
 Broil
Clean
  Stage 1
  Stage 2
  Time

F2-Oven over temperature
F3-Open oven temperature sensor
F4-Shorted oven temperature sensor
FFF-Control failure

120 VAC should be indicated.

See schematic.

100% bake element
100% broil element

Time controlled 30 minutes 100% broil
100% bake
4 hours with last 30 minutes for cool

Verify voltage to clock.
If no voltage is present, check wiring.
If voltage is present, replace clock.

0314907

Temperature sensor

Measure resistances.

Approximately 1100 

O

 at room

temperature 75

º

F.

31940001 - Bake
31939901 - Broil

Ignitor

Test for voltage at terminals.

Test for the amount of amperage in
the circuit.
(Ignitor may glow but not have
sufficient amperage to open valve).

120 VAC

 3.2 

 3.6 Amps, If not replace.

0316211

Bake burner

Verify gas is supplied.

Orifice adjusted for Natural or LP.

Check for obstructions or
contamination in ports.

0060691

Broil burner

Verify gas is supplied.

Proper orifice installed for Natural or
LP.
Check for damage to screen.

Replace if punctured or torn.

Reviews: