Disassembly
To avoid the risk of electrical shock, personal injury, or death, disconnect power to oven and discharge capacitors
before following any disassembly procedure.
!
WARNING
26
16023463
©2006 Maytag Services
Outer
Door
Outer
Insulation
Inner
Insulation
Inner Door
Assembly
Inner Door Assembly
1. Remove outer door, see “Outer Door” procedure.
2. Remove insulation pads from inner door assembly.
3. Remove screws securing inner door assembly to
hinge.
4. Reverse procedure to reassemble.
Hinge
1. Remove outer case, see “Outer Case” procedure.
2. Open oven door and remove screws securing
magnetic door guard from door hinge.
3. Remove outer door, see “Outer Door” procedure.
4. Remove hinge mounting screws from hinge (five on
front, four on side).
NOTE:
Discard foam gasket on side of hinge.
5. When reinstalling hinge mounting screws, keep the
side screws loose and tighten the front screws, close
door, press door against oven on the hinge side and
tighten side hinge mounting screws in the sequence
shown below.
1
2
3
4
Magnetic
Hinge Cover
Door Handle
Remove door handle by removing plastic plugs to gain
access to set screws. Loosen set screws using a
(3/32 inch allen screws), one located to the left of the
door handle and one located on the bottom of the door
handle.
Pointed tip
Flat tip
Plastic plugs
Tighten first
NOTE:
When replacing door handle, tighten side set
screw first and apply LOCTITE.
NOTE:
If set screws are removed, the set screw with
the flat end must be used in the bottom of the
door handle.
Magnetic Door Stop
1. Open the oven door.
2. Remove screws securing magnetic door stop to door
hinge.
3. Reverse procedure to reassemble.
Outer Door
1. Remove door handle, see “Door Handle” procedure.
2. Remove plastic plugs covering screws with a thin flat
blade screwdriver.
3. Remove thumb screws securing door heat shield to
outer door.
4. Remove crows foot screws, securing outer door to
inner door assembly.
5. Remove outer door from inner door assembly.
6. Reverse procedure to reassemble.
