47
RS2310003 Rev. 0
Disassembly Procedures
Unplug power source and shut off gas suppl before servicing,
unless testing requires it.
WARNING
!
Gas Manifold Pipe
1. Turn off power to the range.
2. Turn off gas supply to the range.
3. Partially remove control panel.
4. Remove burner box mounting screws and plug block
and orifice mounting plate mounting screws.
5. Disconnect fan interlock (bucket) switch wire leads
and remove burner box.
6. Remove spark/fan switches from top burner valves.
7. Disconnect top burner supply tubes from top burner
valves.
8. Disconnect gas inlet tubing from manifold inlet elbow.
9. Remove screws securing clock/timer heat shield to
manifold and remove manifold assembly.
10. Transfer top burner valves and gas inlet elbow to
replacement manifold.
11. Reverse procedures to reassemble.
NOTE: After reassembly check all connections for gas
leaks using a soap solution.
Gas Inlet Pipe to Manifold Tube
1. Turn off power to the range.
2. Turn off gas supply to the range.
3. Disconnect gas supply and downdraft venting
ductwork and remove range from cabinet.
4. Remove burner box.
5. Disconnect inlet pipe from manifold inlet elbow.
6. Remove storage drawer from range.
7. Disconnect inlet tubing from inlet manifold fitting.
8. Remove left side panel rear mounting screws.
Carefully pull side panel away from range to allow
removal of inlet tubing.
9. Reverse procedures to reassemble.
NOTE: After reassembly check all connections for gas
leaks using a soap solution.
Inlet Pipe, Pressure Regulator and Street
Elbow
1. Turn off power to the range.
2. Turn off gas supply to the range.
3. Remove storage drawer and disconnect gas supply to
the range.
4. Disconnect inlet manifold tubing from inlet pipe fitting.
5. Disconnect gas valve inlet tubing from shut-off valve.
6. Remove inlet pipe mounting screws and remove inlet
pipe assembly.
Remove pressure regulator by unscrewing it from the
street elbow.
If inlet pipe is being replaced, remove street elbow,
shut-off valve and manifold inlet pipe fitting and install
them on replacement inlet pipe.
7. Reverse procedures to reassemble.
NOTE: After reassembly check all connections for gas
leaks using a soap solution.
Shut-Off Valve
1. Turn off power to the range.
2. Turn off gas supply to the range.
3. Remove storage drawer to gain access to valve.
4. Disconnect gas valve supply tube from shut-off valve.
5. Unscrew shut-off valve from inlet pipe.
6. Reverse procedures to reassemble.
NOTE: After reassembly check all connections for gas
leaks using a soap solution.
Bake/Broil Dual Gas Valve
1. Turn off power to the range.
2. Turn off gas supply to the range.
3. Remove maintop assembly and burner box.
4. Disconnect gas valve wire leads. Label leads for
correct replacement during reassembly.
5. Disconnect broil burner supply tubing, bake burner
supply tubing and valve inlet supply tubing.
6. Remove gas valve mounting screws and remove
valve.
7. Transfer valve mounting brackets to replacement
valve.
8. Reverse procedures to reassemble.
NOTE: After installing the valve check all connections
for gas leaks using a soap solution.
Gas Valve Inlet Supply Tube
1. Turn off power to the range.
2. Turn off gas supply to the range.
3. Disconnect gas supply and downdraft venting
ductwork and remove range from cabinet.
4. Remove burner box.
5. Disconnect inlet supply tube from gas valve.
6. Disconnect supply tube from shut-off valve.
7. Remove left side panel rear mounting screws.
Carefully pull side panel away from range to allow
removal of supply tube.
8. Reverse procedures to reassemble.
NOTE: After reassembly check all connections for gas
leaks using a soap solution.