33
RS1300005 Rev. 0
Disassembly Procedures
!
WARNING
To avoid risk of electrical shock, personal injury, or death, disconnect electrical power source to unit, unless test
procedures require power to be connected. Discharge capacitor through a resistor before attempting to service.
Ensure all ground wires are connected before certifying unit as repaired and/or operational.
4. Grasp evaporator by left side to release coil from
retainer clips.
5. Turn Evaporator slightly to expose heater leads.
6. Disconnect heater leads from harness.
7. Release heater clips holding heater to evaporator coil.
8. Remove heater.
9. Reverse procedure to reassemble.
Ice Maker Removal
1. Remove auger ice bucket and fast freeze shelf.
2. Disconnect ice maker harness from rear bulkhead.
3. Remove front two screws from left ice bucket rail.
4. Remove screws supporting ice maker from side
bulkhead.
5. Remove ice maker.
6. Reverse procedure to reassemble.
NOTE:
Make sure to get fill tube inserted in to fill cup
fully when reassembling
Machine Compartment
Water Valves
1. Remove water valve cover plate on left side of
machine compartment.
2. Disconnect wiring from water valve, reference color of
connector to correct solenoid.
3. Disconnect water tubing from water valves, reference
or mark tubing to ensure correct hookup upon
reassemble.
4. Remove hex screw attaching valve to water valve
cover plate.
5. Reverse procedure to reassemble.
PART OF WATER FILTER
HEAD YELLOW STRIPE
ON TUBE
TO WATER TANK
PART OF TANK
SECONDARY
VALVE
PART OF WATER FILTER
HEAD BLUE STRIPE ON
TUBE
P
RIM ARY
W
AT ER
V
AL VE
T
O
I
C E MAKER
W
AT ER
V
AL VE
C
OVER
Condenser Fan Motor and Blade
1. Remove machine compartment hex screws.
2. Remove cover
3. Disconnect wiring harness connector from condenser
motor.
4. Remove hex screws from mounting brackets
attached to motor.
5. Remove motor and fan blade out the rear of shroud.
6. Remove the retainer nut to remove fan blade.
7. Reverse procedure to reassemble.
Compressor
1. Remove machine compartment hex screws.
2. Remove cover.
3. Remove bale strap which retains overload/relay/
capacitor.
4. Pull overload/relay/capacitor assembly off of
compressor terminals.
5. Disconnect ground wires attached to compressor.
6. Follow reclaiming procedures in Service Procedures
section of this manual.
7. Remove drier.
8. Unbraze low and high pressure lines at compressor.
9. Remove compressor mounting bolts.
10. Lift compressor out of unit.
NOTE:
Install new drier and compressor per
instructions in “Service Procedures.” Evacuate
and recharge sealed system per instructions in
“Service Procedures.”
Condensate Drain Tube
1. Remove machine compartment hex screws.
2. Remove cover.
3. Locate and remove hex screw holding drain tube in
place.
4 Remove drain tube by pulling down on drain tube.
5. Reverse procedure to reassemble
Condensate Drain Pan
NOTE:
Condensate drip pan may spill when steps 1
thru 4 are performed. Have a towel ready to
mop up spillage.
1. Remove machine compartment and water valve
cover hex screws.
2. Remove covers
3. Remove screws holding condenser shroud to base
pan.
4. Raise rear of unit up about three inches and block up.
5. Remove two rear torx head screws holding rear of
basepan to cabinet located under basepan.
Summary of Contents for 22 Cu. Ft
Page 48: ...1 A RS1300005 Rev 0 Appendix A...
Page 72: ......
