AMA PP.26.430, Operator'S Manual

Page: 54 / 101

USING THE UNIT
Preparations:
Wear suitable protective clothing,observe safety precautions. Adjust telescoping shaft to the required
length . Starting the engine. Put on the shoulder strap.
Cutting Sequence:
To allow branches a free fall, always cut the lower branches first. Prune heavy branches (large diameter) in several
controllable pieces. Never stand directly underneath the branch you are cutting – be wary of falling branches.
Note that a branch may spring back at you after it hits the ground – risk of injury.
Disposal:
Do not throw cuttings into the garbage can – they can be composted.
Working Techniques:
Hold the control handle with your right hand, and the shaft with your left hand.Your left
arm should be extended to the most comfortable position.Always hold the shaft with
your left hand in the area of the handle hose.The shaft should always be held at an angle
of 60° or less.The least tiring working position is a tool angle of 60°.Any lesser angle
may be used to suit the situation concerned.
WARNING!
When you use the machine,if the saw chain is locked by the branch,you must move over the saw and
then saw the branch over again .
-13-