Page 34 [email protected] +1(909) 591-8431 www.alvaradomfg.com
Installation Instructions
Yoke Installation
Fig. A2
Fig. A3
Fig. A4
Fig. A5
1.
Determine the installation location for the yoke. Identify
the threaded aluminum block at the top of each section.
(Figure A1).
2.
Push the two sections together (Figure A2).
NOTE
Prior to drilling the anchor bolt holes, use a tape measure and
measure the distance from the bottom bearing plate center
to the outer mounting holes on the two yoke sections (Figure
A1). Adjust the yoke until these two distances are identical.
Mark these two locations.
3.
Use a pencil and trace the entire outline of the yoke
assembly (Figure A3).
4.
Locate the four (4) yoke mounting channels. Position
the mounting channels within the traced outline, as
noted in Step 3. All mounting channels should be
placed 4" from each end of the two Yoke assemblies
(Figure A4).
NOTE
The ground side of each yoke mounting channel should
be facing outward.
5.
Once the mounting channels are in place, mark each
location (Figure A5).
Mounting
Channel
Yoke
Outline
Mounting
Channels
Mounting Hole
Locations
Threaded
Aluminum Block
Yoke Section
Pencil
4.00"
8.00"
CPST Installation Instructions
