BURNER TUBE CLEANING
Follow the procedure that is most convenient for you:
1. Use a small bottle brush with a
fl
exible handle.
Run the brush up through each venturi tube and into the burner several times.
2. Lay the burners down with the venturi tubes facing up, and force water through
them.
At this time, observe each burner port. Make sure water comes out of every hole.
If not, clean the burners as follows
BURNER CLEANING
Regardless of which venturi cleaning procedure you used, we recommend that you
complete the following steps to help prolong burner life.
1. Scrub the entire outer surface of the burner with a non-metallic scouring pad to
remove any loose corrosion.
2. Clean any clogged holes with a sti
ff
piece of wire (for example: an open paper
clip).
3. Inspect the burner assembly for any opening caused by corrosion.
4. If any openings due to corrosion are found, replace the burner.
5. Replace the burner and spring as described in the assembly instructions.
6. Check the burner for proper location/seating after replacement.
7. Ensure that the valve ori
fi
ces are inside the burner tube
VERY IMPORTANT
The location of burner with respect to the ori
fi
ce is vital to safe operation.
Check to ensure the valve ori
fi
ces are inside of the burner tubes before using your
gas BBQ (See Rotary piezo ignitor diagram).
If the burner tubes (venturi) are not
fi
tted over the valve ori
fi
ces and you start
lighting the burners, an explosion and or
fi
re might occur.
9
Burner Control
Gas Valve
Adjust screw
Spark
Burner
Nuts and screws
