Alutech CU-TR230-868, Installation And Operation Manual

Page: 14 / 130

CONTROL UNITS СU-TR230-868 / СU-TR400-868
12 12
SETTINGS
6.2 RadIO CONTROL SETTING
Y
Before programming the remote controls for the first time, clear the memory of the control
unit from the previously recorded radio remote controls. If the remote control is lost, in order to
prevent unauthorized access, it is necessary to delete the number of the lost remote control from
the memory. If the number of the lost remote control is unknown, then delete all the remote
control numbers and re-record all the remote controls.
Settings of menu
P2
:
f1 … f3 — remote control command(s) record ( tab. 5, 6)
f4
,
f5
— changing the control command(s) of the recorded remote control ( tab. 7, 8)
f6 — determination of the remote control numbers ( tab. 9)
f7 — determination of the recorded remote number ( tab. 10)
f8
,
f9
— remote control deleting ( tab. 10, 11)
f0 — deleting all remotes ( tab. 12)
Table 4 describes the radio control commands and the numbering of control commands is pre-
sented in menu P2 .
Table 4
dESCRIPTION Of RadIO CONTROL COMMaNdS
SETTINGS f1–f5
CONTROL COMMaNd MEaNING
NO Control command is not set NO COMMaNd 00
STEP By STEP
Performing actions of opening, stopping
movement, closing. The sequence of actions
is set by setting
P3
–
f3
( tab. 13). When
configuring the outputs of connectors
7
–
9
( tab. 2) for two-way control operation
(settings P3 – f4
…
f6 , tab. 13), the ENTRY or
EXIT direction is determined
STEP By STEP (ENTRY) 01
STEP By STEP
(EXIT)
07
OPEN
Performing of opening. When setting the
outputs of connectors 7 – 9 ( tab. 2) for two-
way control operation (settings
P3
–
f4
…
f6 , tab. 13), the ENTRY or EXIT direction is
determined
OPEN (EXIT) 02
OPEN (ENTRY) 06
PaRTIaLLy
OPEN
From the fully closed door position, the
opening is performed within the time set in
P1 – f9 ( tab. 13)
PaRTIaLLy OPEN 05
CLOSE
Performing of closing
CLOSE 03
STOP Performing of movement stop STOP 04