Altusen KN2132, User Manual

Page: 40 / 310

KVM Over the NET™ User Manual
24
3. If you are using a KA7140 Adapter Cable, refer to page 267 for
setup and operation information.
4. The distance between the switch and the KVM Adapter Cable
must not exceed these lengths: KA7140: 300m; KA71xx: 50m;
KA91xx: 40m.
3. Plug the connectors on the KVM Adapter Cable into the appropriate ports
of the server you are installing. (See Adapter Cable Connection Diagram ,
page 28.)
4. Plug a cable from the LAN or WAN into the KVM Over the NET™
switch’s primary network interface socket.
5. (Optional) Plug another cable from the LAN or WAN into the KVM Over
the NET™ switch’s backup (secondary) network interface socket.
6. (Optional) Use Cat 5e cable to connect the KVM Over the NET™ switch’s
PON port to an SA0142 Adapter. Connect the Adapter to the PON IN port
of a Power Over the Net™ unit.
Note: The PON unit shown in the example is the PN0108. See Supported
Power Over the Net™ Units , page 285, for a list of suitable units.
7. (Optional) Use Cat 5e cable to connect the KVM Over the NET™ switch’s
Modem port to an SA0142 Adapter. Connect the Adapter’s serial
connector to the modem’s DB-9 port.
8. Ground the switch using proper grounding wire to connect the switch’s
grounding terminal to a suitable grounded object.
Note: Do not omit this step. Proper grounding helps to prevent damage to
the unit from surges or static electricity.
9. Plug the power cord(s) supplied with your package into the switch’s power
socket, and then into an AC power source.
For the KN2124v, KN2140v, KN4124v, KN4140v, KN2116v, KN2132v,
KN4116v, and KN4132v when using a single power socket, be sure to turn
on the correct power switch (see
Power Switch , page 16). When using both
power sockets, either of the power switches can be used to turn on the
KVM switch. To enable dual power, turn on both power switches.