6600/Rev/Mar.2021
Page 16
Altronic Research Inc.
Remove the ½-20 X 2” hex head screws at the
bottom of the tower panel as shown in Figure 6.
Remove the three 8-32 Torx head screws that
hold the RF panel to the tower panel, and remove
the tower panel as shown in Figure 7.
The bolts shown in Figure 8 hold
the resistor clip bracket in place.
There are two bolts on each of the
two brackets. They must be
loosened before removing and
replacing resistors. Removing the
resistors without first loosening
these screws may cause the
resistors to break or crack. The
resistors are hard, brittle ceramic
material. Avoid impact and
excessive force when installing or
removing them.
Fig. 7
Fig. 6
Fig. 8
