Alton Evolution Eight Series, Instruction Manual

Page: 19 / 52

19
Roof Assembly
7
The next stage is to fix the first eaves spacer (diagram 18). This should be secured tightly up against
the roof corner bar and fixed with 50mm screws. Now take a roof glazing bar, locate this with the
ridge making sure it is pushed all the way into the mortise in the ridge. Then locate the bottom of
the roof bar with the eaves bar making sure the inside edge sits flat against the eaves bar and drill a
pilot hole vertically down. Make sure this is tight against the eaves spacer then fix this with a 80mm
screw. This screw will go through into the side glazing bar securing the whole joint (diagram 19,
p20).
If you have a partition remember to look at the separate instructions as you need to decide where in
the building you are installing this as the roof bars are different to the standard roof bars.
Dia. 20
Dia. 18
Dia. 19
Diagram 18
50m
m Sc
rew
EV00
24
Dia. 16
External
Keep front
faces flush