Alto Aqua Leader Contempra, General Instructions Manual

Page: 28 / 33

06
SECTION
GENERAL INSTRUCTIONS - OVAL POOLS
ASSEMBLING
THE POOL FRAME
Use the optical level to ensure that the ground
is perfectly flat and level .
IMPORTANT NOTE:
IMPORTANT NOTE
We suggest that you install all the top ledges
on the wall before attaching them.
Insert the outer upright in the bottom joining plate
Slide the outer upright onto the middle bracket of the upright.
(image 6.10)
Secure the outer upright with a Phillips self drilling screw at the top of it. (image
6.11)
12.
Install the outer upright
Skimmer top ledge
Position and place the skimmer top ledge on the upright above the top plates.
Make sure the skimmer top ledge is align with the skimmer and water return holes.
The skimmer top ledge must be pushed toward the inside part of the pool.
(image
6.9)
Partially insert 2 Phillips screw and evenly distribute the space between the two
extrimities. Then, tight up the screws.
6.9
6.10
6.11
2x
1x
TOP
53
13.
Install the ledge covers
Take the rear part of the ledge cover and insert the hooks underneath the top ledge.
Toggle over the rear part of the ledge cover and align the screw hole with the one on the top plate. Attach with a Phil-
lips screw.
(image 6.12)
Take the front part (outside of the pool) and slide it on the top ledges and ensure that the rear part ends are inserted
in the front part. Attach with two Phillips inch screws.
(image 6.13)
Align the top part on the front part and insert the top part rear clips. The top part front clips snap onto the front of
the front part by applying pressure.
(image 6.14)
6.12
6.13
6.14
2x
06
SECTION
GENERAL INSTRUCTIONS - OVAL POOLS
ASSEMBLING
THE POOL FRAME
54
L
L
E
E
D
H
H
G
E