Alto-Shaam Halo Heat 1200-S, Installation, Operation And Maintenance Manual

Page: 11 / 43

1200-S, 1200-UP •
INSTALLATION
/
OPERATION
/
SERVICE MANUAL
-
PG
. 10
1. PREHEAT AT 200°F (93°C) FOR 30
MINUTES BEFORE LOADING FOOD.
Push power switch to “ON” position. The power
button will illuminate.
2.
Rotate the control knob to 200°F (93°C).
The temperature will be displayed on the digital
display.
3.
The temperature display light will illuminate
when the inside air reaches the desired holding
temperature.
4.
Load the cabinet with hot food only.
The purpose of the holding cabinet is to maintain
hot food at proper serving temperatures. Only
hot food should be placed into the cabinet.
Before loading the unit with food, use a food
thermometer to make certain all food products
are at an internal temperature range of 140° to
160°F (60° to 71°C). All food not within the
proper temperature range should be heated
before loading into the holding cabinet.
5.
Check to make certain the cabinet door is
securely closed, and rotate the control knob to
160°F (71°C).
THIS WILL NOT NECESSARILY
BE THE FINAL SETTING.
The proper temperature range for the food being
held will depend on the type and quantity of
product. Whether or not the door vents should be
open or closed will also depend on the type of
food being held. When holding food for
prolonged periods, it is advisable to periodically
check the internal temperature of each item to
assure maintenance of the proper temperature
range. Reset the holding temperature accordingly.
TO TOGGLE BETWEEN FAHRENHEIT
AND CELSIUS
The factory default is Fahrenheit. To change to
Celsius:
1.
With the control OFF (i.e. temperature setting in
the OFF position), press and hold the Temperature
Display button for 5 seconds.
2.
The control will show “degC” for 3 seconds to
verify selection and then show the temperature.
(Set Point or Actual, whichever the user has
selected) in ºC.
3.
Repeat to toggle to Fahrenheit.
No te: With a p o w er failure, facto ry test, etc., the
co ntro l w ill retain the ºC o r ºF setting selected by the
user w hen p o w er is resto red .
POWER FAILURE
When power is lost, then resumes, the display will
flash “-AC-” for 4 seconds, then display the set
holding temperature for 4 seconds and will alternate
until acknowledged. To acknowledge, press any key.
This feature will alert you when there is a power
failure, indicating that food safety may be
compromised.
I
o
I
o
On/Off
Power
Switch
Digital
Display
Temperature
Control Knob
Temperature
Display
Button
Temp
Display
Light
O P E R A T I O N
M A N U A L C O N T R O L O P E R A T I O N