IN STA L L ATION / OPERATION / SERVIC E MA N UA L • 9.
E l e c t r o n i c C o n t r o l
Timer Programming Information
1. Tur n On/Off Power Key OFF.
Press the
ON
/
OFF KEY
until the display turns
OFF (at least 2 seconds).
Note:
The following steps can only be
done when the
ON
/
OFF KEY
is OFF.
2. Set Shelf Timer Keys.
Press and hold a
SHELF TIMER KEY
(at least
2 seconds) until a value is shown in the
LED
DISPLAY
. Use the
UP OR DOWN ARROW KEY
to change the time desired.
3. Set Additional Timer Keys.
Repeat step 2 for each
SHELF TIMER KEY
to be programmed.
4. Tur n On/Off Power Key ON.
When selected timers have been programmed,
press the
ON
/
OFF KEY
to turn ON unit.
5. Press Shelf Timer Key.
Press selected
SHELF TIMER KEYS
to activate.
Shelf LED
DISPLAY
will illuminate and the
count down will begin.
The
SHELF TIMER KEY
LED with the least amount of time
remaining will flash slowly and the LED
DISPLAY
will
alternate between hold temperature and time
remaining.
6. Tur n OFF alarm.
Listen for beeping alarm. Press flashing
SHELF TIMER KEY
to turn OFF alarm.
Reprogram Shelf Timer Keys
If you wish to reprogram holding times, turn OFF
power. Press the desired
TIMER SHELF KEY
and input
new time using
UP OR DOWN ARROW KEY
. Turn unit
ON and press each
SHELF TIMER KEY
to start the
count downs.
Important Note:
Timer Station Key retains initial
time settings in memory.
Count down times are cancelled
when
ON
/
OFF KEY
is turned OFF.
It may help to note any remaining
count down times before
reprogramming.
Power Failure:
If a power failure occurs while the
unit is running, you will not be
able to change the control
temperature. Simply depress the
ON
/
OFF KEY
to resolve. The timer
memory will not be impaired.
O P E R A T I O N
The Multiple Shelf Timer Key feature is
exclusively available for the electronic control. These
keys monitor food safety by using a timer-based
"First-In, First-Out" product management system.
Products should be cooked to HACCP
recommended internal temperature and then held in
the unit. The Timer system allows operator to select
holding times when the unit is loaded. Multiple timer
keys correspond to various pan locations in the
holding unit. As the timers expire, audible alarms
notify the operator.
