Micro VoIP 200
User Manual
v1.53
8
2. Basic Installation
Micro VoIP 200 is designed to be installed easily. Before installation, connecting a computer or a
Notebook PC to the LAN port of Micro VoIP 200, setting the network environment of the computer to
be static IP with IP address 192.168.1.xxx (could be for example 192.168.1.100). Then log into Micro
VoIP 200 with the web browser on the connected Notebook/PC. The default value of the LAN IP of
Micro VoIP 200 is 192.168.1.1.
There are only three things that must be followed to let the Micro VoIP 200 work:
1.
Configure the LAN IP of Micro VoIP 200 – if there is already another DHCP server (another
NAT/Router device) existed in the LAN network, you must make sure that they are not using
the same sub networks; otherwise you need to change the LAN IP of Micro VoIP 200 to a
different sub network.
2.
Configure the WAN IP of Micro VoIP 200 – depends on the internet connection of the office,
you can configure the WAN IP as PPPoE, DHCP or static IP.
3.
Configure the users of the Micro VoIP 200 – the user management page of the configuration will
allow you to determine the number/password and other things that you needed to let the IP
Phone register to this Micro VoIP 200. For more detailed configurations, please go to section
2.2.
After the three basic configurations, you can install the IP Phone on the LAN network, the IP Phone
will automatically find this Micro VoIP 200 and get its user configuration and function immediately. Of
course, there are something needed to be noticed to let this auto-installation work correctly, please go to
section 2.2 for detailed description.
Figure 1 The installation environment of Micro VoIP 200(Micro VoIP 200 used as a IP PBX only)
