D-000348 Rev. A
26
mph (.16 km/hr) increments up to a maximum of 3 mph (4.8 km/hr). Holding either
button down for more than 2 seconds causes the speed to increment or decrement at a
faster rate.
Note: For speeds above a value of 10 (for both mph and kph) the speed display
alternates between the integer and fractional speed setting.
STEP 6: ADJUST TREADMILL GRADE
Press the + button to increase grade, press the – button to decrease grade. Holding the
button down for more than 2 seconds will cause grade to change at a more rapid rate.
Note: Treadmill grade cannot be adjusted greater than 5% if speed is set for less
than .5 mph (.8 km/hr).
STEP 7: ENDING THE EXERCISE SESSION
Return the treadmill to 0% incline before stopping your session.
Press the STOP button to end exercise.
FUNCTION OF THE PAUSE BUTTON
Press the PAUSE button to place the treadmill in the pause mode. The tread belt will
stop but all statistical information will be preserved. Body weight support is maintained
while in the pause mode. Press the PAUSE button again to resume exercise.
STEPPING OUT OF THE TREADMILL
Wait for the tread belt to stop and the enclosure to fully deflate before exiting the
system. Unzip your shorts and pull the top “skirt” of the shorts from under the enclosure
lip. Open the cockpit lock to disengage it from its locked position. Lower the cockpit
onto the surface of the tread belt and exit to the rear of the system (figure 5). After
exiting the system, return the cockpit to an upright, locked position.
