7
Make sure that the crossover unit is disconnected of the mains.
In the crossover rear panel, is placed the mains connector and the fuse holder. The box
bellow this mains connector is called fuse holder. Take out the fuse holder.
Upon extracting the fuse holder, the fuse will appear, take out it and change for the new
one.
Insert the fuse holder into the mains connector again.
CAUTION: Always make sure upon changing the fuse, of that is the adequate for the se-
lected mains voltage (T1A for 115V and T0,5A for 230V).
CONNECTION TO THE MAINS
The connection of the crossover power supply to the mains takes place by a tripolar
cord provide by the factory.
Make sure that the crossover power switch, is at position 0 (turned off).
Insert the female connector of the tripolar cable into the crossover power
supply male connector, placed at the rear panel.
Insert the male connector of the tripolar cable into the mains plug.
Turn on the crossover power switch. In that moment the MODE LED
indicator will light, indicating that the crossover is turned on.
CAUTION: Make sure that the mains tension to the one which is going to
connect the crossover unit is correct, as well as their fuse is the adequate.
INPUT CONNECTION
The crossover signal input, is carried out through two XLR-3-31 females connectors, one
per channel. The input connections are balanced, with a nominal impedance of 20 K
Ω
(10
K
Ω
unbalanced).
2
1
4
3
1
4
3
2
