16
The ATTACK and RELEASE resistors are present in the frequency card, which define the
limiter times of attack and release of the way placed at left of the frequency card, looking at
the crossover from the frontal. The last way, upon not providing of these resistors in the
frequency card, it has them in the main board:
MODEL
WAY —» HIGH R
ATTACK
RELEASE
FA-724
R379
R389
FA-524
R326
R336
Also one must highlight that the phase adjustment configuration corresponding to the
way located at left of the frequency card, looking at the crossover from the frontal, is placed
in the frequency card. This is a capacitor and comes numbered as:
∅
.
In order to setup the frequency card like bypass, will remove the integrated circuit U1,
and the resistor arrays R1, R2 and R3 of the frequency card, and will place the links BYPASS_1,
BYPASS_2, BYPASS_3 and BYPASS_4. Don't forget to leave the ATTACK and RELEASE resistors
and the capacitor
∅
in the frequency card, since these define the attack and release times,
as well as the phase adjustment of the way located at left of the frequency card looking at
the crossover from the frontal:
The frequency cards are placed in the connectors J3, J6, J9, J12, J15 and J18, witch
correspond with the numbers 1,2,3,4,5 and 6 of the main board.
In the next table could be found the most of the frequencies that one could define in the
frequency card:
