Altai Technologies Ltd. All rights reserved
A8n Series Super WiFi Base Station Installation Guide
TPS13-002_rev1.0
3.
Start wrapping a layer of electrical tape 1” (25mm) below the butyl rubber tape,
overlapping at half-width. Finish the wrap at the base of the A8n series 5GHz
antenna RF port and cut the tape. Repeat this process for a second layer, and if
enhanced UV protection is required, a third layer.
7.
Recommendation on Installation Pole
7.1.
Antenna Pole Height and Size
The antenna should be mounted at least 1 meter above any obstacle in front. Hence,
the height of the pole depends on the situation. In the situation shown below, the
pole should be at least 2 to 3 meters to avoid any obstacle. The mounting kit can
mount the pole with diameter from 1.5 inches to 3 inches.
Remark: 2 inches pole is recommended as it can install A2 and 5GHz 20dBi panel
antenna in the same pole also.
Figure 7-1 At Least 1m above Any Obstacle in Front
7.2.
Grounding Protection
