Altai Technologies Ltd. All rights reserved
A8n Series Super WiFi Base Station Installation Guide
TPS13-002_rev1.0
The A8n series must be properly connected to earth ground. Failure to do so may
result in equipment damage, injury or death. Product warranty does not cover
damage resulting in part or in whole from improper grounding. An external grounding
wire must be installed, especially when A8-Ein is deployed on a non-metal pole or the
metal pole is not properly grounded. Please consult your location’s building and
electrical codes and follow them, or consult standards such as National Electric Code.
The grounding screw is located at the bottom of A8n series as showed in figure 30.
Use 10 AWG wire with corrosion-resistant connectors for connecting to one or more
approved grounding rods or building’s earthling network. Earth-to-ground resistance
should not be more than 10ohms.
1.
Loose the grounding screw of A8n series.
2.
Attach a length 10 AWG bare copper with a terminal connector to the
grounding screw.
3.
Tighten the screw nut.
4.
Connect the other end of grounding wire to grounding rods or earth ground.
Figure 7-2
Grounding Screw
8.
Ethernet Connector Packet Installation
The Ethernet connector packet includes the following components:
1.
Gasket
2.
Housing
3.
Screw Nut
4.
Clamping Ring
