Altai Technologies Ltd. All rights reserved
A8 Installation Guide_ R3 Hardware Platform
TPS13-010_rev1.0
cut the tape. Repeat this process for a second layer, and if enhanced UV
protection is required, a third layer.
Figure 12-13 Wrapping Direction of the Antenna End
Figure 12-14 18dBi 5GHz antenna port without wrapping
Figure 12-15 18dBi 5GHz antenna port with
rubber wrapping
13.
Recommendation on RF cable and Antenna Pole
13.1.
RF Cable
A RF cable should be assembled with N-type male connectors at both ends.
The length and diameter depend on the site situation. Our recommendation is that
the insertion loss of the RF cable should not be greater than 1dB at 2.4GHz
(for802.11b/g) or 2dB at 5.8GHz (for 802.11a).The standard RF cable provided by
Altai is 2 meters in length. Its insertion loss is 0.7dB at 2.4GHz and 1.0dB at 5.8GHz.
