37
-EN
01GB04INE-W947E.fm
ALPINE INE-W947E 68-24567Z10-A (EN)
Setting item: Tint
Setting content: R15 to G15 (Initial setting: 0)
Adjust the colour from R15 to G15.
Setting item: Contrast
Setting content: -15 to +15 (Initial setting: 0)
You can adjust the contrast between LOW (-15) and HIGH (+15).
When it reaches the minimum or maximum point, the display
shows “LOW” or “HIGH” respectively.
Setting item: Sharp
Setting content: -5 to +5 (Initial setting: 0)
Picture quality adjustment range is -5 to +5. “SOFT” and “HARD”
appear as the minimum and maximum values specified.
When adjusting audio (video media), you can store the settings made
for “Adjusting Live Contrast, Brightness, Colour, Tint, Contrast and
Sharp.”
Setting item: Preset1 / Preset2
1 After completing “Adjusting Live Contrast, Brightness,
Colour, Tint, Contrast and Sharp” (page 36, 37), touch
and hold
[Preset1]
or
[Preset2]
to save the settings.
2 Touch
[Preset1]
or
[Preset2]
to call the saved settings.
•
Display Mode cannot be registered.
About INE-W947E
Touch
[About]
on the General setup menu in step 3. Refer to “General
Setup Operation” (page 33).
You can view the version information of this product. Make note of this
information and refer to it whenever you contact Alpine Tech Support or
an Alpine-authorised dealer.
Setting item: Version Info
Contents: Serial No. / Firmware Version
This unit will display the registration code required to play a DivX
®
VOD (Video On Demand), or you can also display the deregistration
code.
Setting item: Warranty / Copyright Info.
Displaying the Registration Code
1
Touch
[Warranty/Copyright Info.]
.
2
Touch
[DivX(R) VOD]
.
3
Touch
[Registration]
.
The registration code is displayed on the screen.
4
Touch
[OK]
.
Displaying the Deregistration Code
1
Touch
[Warranty/Copyright Info.]
.
2
Touch
[DivX(R) VOD]
.
3
Touch
[Deregistration]
.
The confirmation dialog screen appears.
4
Touch
[OK]
.
The deregistration code is displayed on the screen.
•
When you have finished, touch
[Cancel]
. If you want to continue and
display a new registration code, touch
[OK]
, check the registration
code, and then touch
[OK]
again.
You can initialise all data, to restore the factory settings. Remove the
CD/DVD disc, etc. from the system before operation
Setting item: Restore Factory Setting
1
Touch
[Restore Factory Setting]
.
2
After the confirmation message appears, touch
[OK]
.
The confirmation screen appears again.
3
Touch
[OK]
.
The system starts initialisation.
•
Do not turn on/off the power or change the ignition key position until
system restart is completed.
Adjusting Tint of Picture
Adjusting Image Contrast
Adjusting Picture Quality
Saving and calling the adjusted picture
quality
Displaying the Product Information
Checking the DivX
®
Registration
Initialising the System
01GB00INE-W947E.book Page 37 Tuesday, April 9, 2013 1:33 PM
