ALPINE HCE-C300R_EN 68-18693Z26-B (A5)
32
-EN
7
Press
SET.
repeatedly to change the
value of “Depth.”
You can specify the depth in 0.5 inch/1 cm
increments by pressing SET..
Setting value:
0 to 11.5 inches/0 to 30 cm
8
Press
VIEW
, select “Height,” and press
SET.
repeatedly to change the value.
You can specify the height from the ground
to the camera in 0.5 inch/1 cm increments by
pressing SET..
Setting value:
17 to 51 inches/
43 to 130 cm
9
Press
VIEW
, select “Offset,” and press
SET.
repeatedly to change the value.
You can specify the offset value in 0.5 inch/1
cm increments by pressing SET..
Setting value:
-15.5 to +15.5 inches/
-40 to +40 cm
The right side of the vehicle is plus and the
left side is minus.
•
10
Press
VIEW
, select “Vehicle Width,” and
press
SET.
repeatedly to change the
value.
You can specify the car width in 2 inchs/5 cm
increments by pressing SET..
Setting value:
56 to 86 inches/
140 to 220 cm
Do not specify a value less than the actual
car width.
If there is no setting that matches the
vehicle width, set the nearest value larger
than the actual vehicle width.
11
Press
VIEW
, select “Next,” and press
SET.
to execute.
The Camera Angle Adjustment screen
appears.
12
Press
SET.
repeatedly until the
calibration sheet is parallel to the orange
lines.
You can specify the angle in 0.5° increments
by pressing SET..
Pressing VIEW repeatedly selects the left
arrow, right arrow, “Next” switch, left arrow,
etc.
A slight lag time exists between pressing the
switch and the screen display change.
13
Press
VIEW
, select “Next,” and press
SET.
to execute.
The Camera Angle Adjustment screen
appears.
•
•
•
14
15
T
16
17
T
