Alpine HCE-C200F, Owner'S Manual

Page: 10 / 17

9
-EN
ALPINE HCE-C200R 68-09359Z09-A (EN)
Installing to a Rear Window
1
Assemble the camera mounting
3
.
Use the hexagonal wrench
5
to remove the
camera mounting
3
and angle adjustment
screw. Remove the mounting brackets, invert
them, and then secure by tightening the
angle adjustment screw.
2
Attach the camera to the camera mounting
3
.
Pull the camera cable through to the camera
mounting
3
, and secure with the hex screws
4
.
3
Loosen the camera mounting
3
and angle
adjustment screw.
Determine the attachment angle, and
carefully tighten the angle adjustment screw.
4
Remove any dirt, dust, oil or chemicals from
the rear window using a commercially-
available cleaning cloth.
5
Remove the adhesive seal from the camera
mounting
3
, and attach the camera
mounting.
• Attach the camera in a position where it does not obstruct
rear visibility, or touch wipers.
• Install the camera facing up so that the serial label on the
rear of the camera is visible.
1
3
3
Securing the Camera Cable
1
Secure the camera cable.
Attach the waterproof pad
7
with the
waterproof pad adhesive sheet
8
, and
secure any slack cable around the waterproof
pad
7
using the cord clamp
9
.
• Ensure the cable does not get caught in the trunk, rear
door(s) or any hinges.
• The cable should go on the outside of car hinges and
harness covers.
• After completing wiring, open and close the trunk and the
rear doors several times to confirm the cable is not getting
caught or rubbing anywhere.
1
9
7
Reverse In
Camera cable
Angle adjustment screw