LiftCallLineC
– User guide
33
Character k
is common first character (0-9,*,#) for all four type of confirm code.
The last possibility to call confirm is dial hangup code (parameter 43).
2.2.5 Machine room connection
Connection between machine room and BraveLLW is same as normal
conection telephone line - two wires. In Machine room is equipment powered
from 12-24V (switchboard), which allows the connection of the telephone line,
the telephone and one to three parallel connected communicators. The reason
is that during machine room communication is disconnected telephone line. The
BraveLLW accept machine room call as incoming, it means you can programm
the unit , control otputs/ inputs. The call is normal time limited and prolong is
automaticaly from SwitchBoard by DTMF.
The call is activated by picking up of phone. The BraveLLW picks up
immediatelly (if you use one communicator) or after address decode - parallel
connection (2-3 communicators parallel connection). This status is indicated by
green indicator. You can make voice communication. The call duration is in
paramerter 51. Switch board is programable device and for right function is need
program same parameters to the BraveLLW and to the SwitchBoard.
As new feature is possibility call directly from BraveLLW to the machine
room. This call is make from BTN1 button
– three times press the button.
2.2.6 Incoming call
Incoming call is coming from outside to BraveLLW. After extension dialling
or land line number where is BraveLLW connected the BraveLLW is ringing and
after preprogrammed number of rings (parameter 46) the BraveLLW picks up
and you can speak to lift cabin.
Exceptional is first 10sec, where is additionally possible insert "# and
service password" (
parameter 44
), to enter programming mode.
When jumper "SERVIS" on BraveLLW basic board is closed you are
automatically going to programming mode when call is picks up. ( without service
password). It is usefull when you forget service password and by this way you
can programm the new one. Do not forget disconnect jumper after programming
. Jumper is on the basic board (page 9).
Incoming call is detected by green indicator. It is possible voice
communication. After confirmation by code behaves the same as described in
chapter 32.
BraveLLW lift communicator enables a special mode -
parallel
connection
of several communicators. Moore about in the next chapter.
2.2.7 Parallel connection BraveLLW communicators
In this mode (parameter 45) is the outgoing call control voltage telephone
line and for incoming call here the system is addressing DTMF which
communicator should stay pickuped. Therefore it is important to set the number
