AlphaDynamik ATLAS C Series, Installation, Operation And Maintenance Manual, Page: 7 / 44

1 . 4 . 1 . D u r i n g i n s t a l l a t i o n
The Technical Specifications of Chapter 8 should always be observed.
§
Never start up the pump before it has been connected to the tubing.
§
Check that the motor specifications meet the requirements, especially when working
under conditions that involve the risk of explosion.
During the installation, all the electric work should be carried out by authorised personnel.
1.4.2. During operation
The Technical Specifications of Chapter 8 should always be observed. Under no
circumstances can the limit values specified be exceeded
NEVER touch the pump or the tubes during operation when the pump is being used to decant
hot fluids or when it is being cleaned.
The pump contains moving parts. Never place your fingers inside the pump while the pump
is in operation.
NEVER operate the pump with the suction and delivery valves closed.
NEVER spray the electrical motor directly with water. The protection standard for the motor is
IP-55: Protection against dust and sprayed water.
1 . 4 . 3 . D u r i n g m a i n t e n a n c e
The technical specifications of chapter 8 should always be observed.
NEVER dismantle the pump before the tubes have been emptied. Remember that some of the
fluid will always remain in the pump housing (when no drainage is provided. Note that the
pumped fluid may be dangerous or very hot. Consult the regulations in effect in each
country for these cases.
Do not leave parts loose on the floor
ALWAYS disconnect the pump from the power supply before starting maintenance work.
Remove the fuses and disconnect the cables from the motor terminals.
All electrical work should be carried out by authorised personnel.
1.4.4. Compliance with the instructions
Any non-fulfilment of the instructions may result in a risk for the operators, the environment and the
machine, and may result in the loss of your right to claim damages.
This non-fulfilment may result in the following risks:
•
Failure of important functions of the machines/ plant.
•
Failure of specific maintenance and repair procedures.
•
Possibility of electric, mechanical and chemical risks.
•
Will place the environment in danger due to the release of substances.
1 . 4 . 5 . G u a r a n t e e
Any warranty provided shall immediately be cancelled and void ipso jure, and ATLAS S/C/W PUMPS
shall be compensated for any product liability claim from third parties, if:
§
the service and maintenance work was not carried out in accordance with the service
instructions, or the repair work has not been carried out by our personnel or it has been
conducted without our written authorization;
-7-