Compiled and designed by Publications 2000, Tel (01670) 356211
08/04/D134
Part No. 6.0001127
c.
When the boiler has been hung in position on the wall
and the remainder of the installation completed, i.e.
flue, all pipework tested and commissioned etc,
position the anti-theft clamp over the boiler back plate
and over the security bolt as shown in Fig. 2.
Fig. 3
d.
Fit the shear nut to the bolt and gradually tighten until
it retains the clamp to the wall, see Fig. 3, continue to
tighten until the nut shears off the cone.
Notes:
i.
Access to the shear nut is from the front
of the boiler, see Fig. 4, using a 19 mm
socket.
ii. Do not tighten the shear nut until the
whole system has been completed, as
once the bolt is fitted, the boiler can only
be removed by drilling out the bolt with a
hardened drill until the cone falls away.
e.
Before leaving site, stick the warning label supplied
to the outer casing of the boiler.
Fig. 2
Fig. 4
These instructions have been carefully prepared but we reserve the right to
alter the specification at any time in the interest of product improvement.
© Alpha Therm Limited 2004.
Alpha Therm Limited.
Nepicar House, London Road, Wrotham Heath,
Sevenoaks, Kent TN15 7RS
Tel: 0870 3001964
email: [email protected]
website: www.alpha-boilers.com
