Alpha Telecom UT3620 Triple NT1, Installation Manual

Page: 10 / 27

Step 2: Connect the DC power plug of the power
supply to the power connector on the rear of the
UT3620 as shown in
Figure 4 . Place the power
cable into the wire clip to secure it.
Plug the power supply into an AC power outlet.
The Power LED will illuminate green and stay
solid indicating the UT3620 has power. The Line
Status LEDs will flash green once to indicate
each interface is receiving power.
If any of the LEDs do not illuminate appropriately,
repeat this step to verify all connections are
secured. If the symptom persists, contact
technical support for assistance.
Step 3: Connect the RJ-45 end of the hybrid
cable provided to the U-Interface connector on
the UT3620 as in
Figure 5 , then connect the
RJ-11 end of the hybrid cable to the U-Interface
outlet.
Figure 4. Power Connector
Figure 5. U-Interface Connector
4 UT3620 NT1 Installation Guide Triple